FACS calibur filter problems
william nostrom (slickwilli@hotmail.com)
Wed, 09 Apr 1997 08:08:11 PDT
Hello Flowers
This is for all of you who have use the FACS Calibur. I have been having
problems with the laser air filter on my instrument. This is the filter that
sits above the sheath/ waste drawer, and below the laser assembly. Everytime I
open the drawer, the sheath tank fluid resistor cap catches the edge of the
filter and tears it apart. I ahve gone through four filters within a very short
period of time because of this. I have an alder FACScan, and I compared the
filters, and have noticed that the filter on the calibur is about 1/8 of an inch
thicker than that on the Scan. I also believe that the older filter is made
sturdier. I ahve called BD about this, and theu assured me that they would look
into it, but haven't heard of anyone else having problems.
My question then, IS anyone else having these problems? I just ordered these
filters, so I am thinkng that they may just be defective. If anyone is having
problems, you should call the BD customer support number.
Thanks
Bill
---------------------------------------------------------
Get Your *Web-Based* Free Email at http://www.hotmail.com
---------------------------------------------------------
CD-ROM Vol 3 was produced by Monica M. Shively and other staff at the
Purdue University Cytometry Laboratories and distributed free of charge
as an educational service to the cytometry community.
If you have any comments please direct them to
Dr. J. Paul Robinson, Professor & Director,
PUCL, Purdue University, West Lafayette, IN 47907.
Phone: (765)-494-0757;
FAX(765) 494-0517;
Web
http://www.cyto.purdue.edu
, EMAIL
cdrom3@flowcyt.cyto.purdue.edu
